On test server
Thermo couple
Hrrrmmp!
OPTO isolation slot
Good policy - wasn't implemented
YOUYOE 858D+ hot air soldering station
Intelligence inside
A little mishap
Painful camera setup
50 chips
YOUYUE 858D+ PCB
YOUYUE 858D+ PCB
That didn't last very long
Some shrinking tube for mechanical support
An Evil Cable
Fixed safety-earth cable
Not enough wire
That is evil
Wire routing
Added ISP connector
Hopefully the final programming
Insulation only works if it doesn't slip
Back to an orderly state
Propped up
IMGP8559.JPG
Not so safe safety-earth connetion
Not so safe safety-earth connetion
Doesn't stick and melts when device is on
IMGP8557.JPG
IMGP8553.JPG
IMGP8558.JPG
Misaligned bolt hole
IMGP8550.JPG
IMGP8549.JPG
IMGP8552.JPG
Should I be concerned?
IMGP8538.JPG
IMGP8536.JPG
Egg warmer
OP-70 precision opamp
7805
IMGP8542.JPG
IMGP8547.JPG
IMGP8541.JPG
IMGP8539.JPG
IMGP8540.JPG
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
235 visits
I had to redo the lousy ground wire
I tried to solder the previous wire to the metal tube, but that didn't work. It gets too hot when the thing is on. A spade connector would be ideal...
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2025
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.