On test server
IMGP8552.JPG
IMGP8549.JPG
IMGP8550.JPG
Misaligned bolt hole
IMGP8558.JPG
IMGP8553.JPG
IMGP8557.JPG
Doesn't stick and melts when device is on
Not so safe safety-earth connetion
Not so safe safety-earth connetion
IMGP8559.JPG
I had to redo the lousy ground wire
Thermo couple
Hrrrmmp!
OPTO isolation slot
Good policy - wasn't implemented
YOUYOE 858D+ hot air soldering station
Intelligence inside
A little mishap
Painful camera setup
50 chips
YOUYUE 858D+ PCB
YOUYUE 858D+ PCB
IMGP8538.JPG
IMGP8536.JPG
Egg warmer
OP-70 precision opamp
7805
IMGP8542.JPG
IMGP8547.JPG
IMGP8541.JPG
IMGP8539.JPG
IMGP8540.JPG
IMGP8536.JPG
IMGP8531.JPG
IMGP8535.JPG
Isolation slot
OPTO + TRIAC + SNUBBER
IMGP8528.JPG
IMGP8530.JPG
Some cleaning would have been nice
IMGP8521.JPG
IMGP8517.JPG
IMGP8519.JPG
IMGP8522.JPG
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
230 visits
Should I be concerned?
The top two wires / traces carry 220V AC. The next one is safety-earth. Then 24V DC for the fan, then 2 wires for the thermo-couple, and lastly 2 wires for a reed switch.
Let's hope those line-voltage carrying wires don't overheat and melt their insulation.
Let's hope those line-voltage carrying wires don't overheat and melt their insulation.
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2025
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.