All sides done
Close up of the pins
Finished RGB LED
91Ω
Left side done
Tacking down the ATmega168
Tacking down the RGB LED
110Ω
Finished front side - The Spider is waiting
Voltage regulator
10µF bypass capacitor
Bypass cap. + autoreset capacitor
10k&Omega RESET pull-up resistor
Tantalum cacacitors
Cutting the header
Female header
Split female header
Female header
Single contact
Cutting the header
Cleaned front side
Serial header
Demo - GREEN
Tantalum capacitors - 10µF
Female header
10kΩ
390Ω
Ceramic capacitors - 100nF
Ceramic capacitor - 10µF
ATmega168
Low drop voltage regulator
Low profile jumper
Male hader - 6pin
Male header - 3x2pin
Male header - 1x3pin
IKEA SUNNAN - battery pack
IKEA odyssey - self inflicted
IKEA odyssey - self inflicted
A male mosquito - about to die
IKEA SUNNAN - lamp corpus
IKEA SUNNAN - solar cell
IKEA SUNNAN - LED
IKEA SUNNAN
IKEA SUNNAN
IKEA SUNNAN
See also...
Keywords
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
86 visits
RGB LED


The plastic melts very easily. Keep the soldering time to an absolute minimum. Sn60Pb40 solder and 240°C works fine.
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2025
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.