Added spacers to make it fit
Bleep Labs Nebulophone
9mm round
Why do I have to
Dumped its load
9mm round
9mm round
I know where I would shove it!
Stereo adapter... yeah right!
Can't get it up
The ugly
Definitely a quality product
Say no more!
The good
The bad
Debugging avrdude - arduino.c
In it went
Flags all over the place
Nipon flag
FIFA Women's World Cup 2011 - FAN-atics
Quoting StarWars didn't help - Yoda was sleeping ?
Japan won
Japan won
Bleeplabs Nebulophone
Battery compartment mod
Preparations for brain surgery
Preparations for brain surgery
The patient is well again !
Mental illness in microcontrollers
Cured subject
Sniffing SPI traffic - RLE enabled
Sniffing SPI traffic - RLE enabled
Sniffing SPI traffic - RLE enabled
Sniffing SPI traffic - RLE enabled
Testing the soft-uart receiver on an ATtiny24
OLS - UART sniffing
Openbench logic sniffer
OLS - UART sniffing
OLS - UART decoding
Mr. Poop
Mr. Poop
CFL - a lamp of the past
CFL - closeup
CFL - ever wondered why many of them stink ?
Blackbird activity
See also...
Keywords
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
115 visits
6.3mm headphone jack


I had to mill away a few mm. Otherwise the jack would not have been flush with the PCB. Three solder joints are in the way.
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2025
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.