My improved ground clip vs. the standard one
Didn't test any of it
Recursion...
GODJIRA
Probe hook and GND stuff
Usual probe hook
Probe GND to header
Nude Godjira
Popped package
Salvaged dual N-MOSFETs
Li-Ion - positive terminal
Li-Ion batteries
A little BOMB - potentially
Li-Ion deep discharge experiment
Please identify this
Bad attempt
Experimental wire bending
Advanced wire bending
Advanced wire bending
Attached wire construct
More wire added
Wire ring added
LED board + wire harness
In it goes
What's wrong?
Bodge wire
Good quality clip
Godjira is hungry!
Not perfectly aligned
TSOP38238 ready - IR control
TSOP38238 ready - IR control
LUFA-based avrispmkII clone - www.bravekit.com
Digi 35 CPU - voltage overshoot
Digi 35 CPU - voltage overshoot
Digi 35 CPU - voltage overshoot
Digi 35 CPU - voltage overshoot
Digi 35 CPU - voltage overshoot
Digi 35 CPU - voltage overshoot
Digi 35 CPU - voltage overshoot
C26 hack
C26 hack
Shunt resistors
TL084 quad opamp
Power supply investigation
DIGI 35 CPU A
See also...
Keywords
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
97 visits
Finally fixed


The solder job is not too brilliant. Too much insulation for a proper crimp. But it works. The shrinking tube helps too.
I should like to find out where to get these clips. I have a feeling I might need more...
I should like to find out where to get these clips. I have a feeling I might need more...
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2025
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.