Michiel 2005's photos with the keyword: automatic transmission

Automatic transmission 722.112 under a 1980 Mercedes-Benz 280CE.

Automatic transmission 722.112 under a 1980 Mercedes-Benz 280CE.

Automatic transmission 722.112 under a 1980 Mercedes-Benz 280CE.

Replacement transmission on a Mercedes-Benz 300TDT.

Modulation pressure to be precise. Should be 2.9 bar at 50 km/h with no vacuum on the modulator.

Modulation pressure to be precise. Should be 2.9 bar at 50 km/h with no vacuum on the modulator.

The Tauschaggregat has the number on the little plate, original transmissions have the number above the oil pan.

Officially you should check the vacuum control valves by turning the engine off and check with the residual vacuum. You can also put in a T joint and connect a vacuum meter. Then you can check while the car is running or during driving.

Officially you should check the vacuum control valves by turning the engine off and check with the residual vacuum. You can also put in a T joint and connect a vacuum meter. Then you can check while the car is running or during driving.

The vacuum is needed to control the automatic transmission. On this particular model the vacuum controls both the shift points and the quality of the shift (hard or soft). When you don't press the accelerator, full vacuum (-0.75 bar) from the pump is fed to the transmission. When you press the accelerator the switchover valve connects the transmission to the output of the vacuum control valve on the diesel pump. The vacuum goes to -0.4 bar, the transmission shifts from 2nd to 1st gear. If you press the accelerator further, vacuum goes to 0 bar at full throttle. Less vacuum means later and harder shifts. Of course all these vacuum parts can fail after 30 years and then the shifts become hard and/or erratic.