Confused trigger
This trigger point looks right
MIBAM
Confused trigger
MIBAM
MIBAM - OK ISR run time
MIBAM - delayed interrupt
MIBAM - bad ISR runtime
MIBAM
MIBAM - trying to get it to trigger
MIBAM
MIBAM
Confused trigger
Confused trigger
MIBAM
Dirty little bugger
Dirty little bugger
Solder joint fatigue
Fixed Floppy Drive
Creating a DSO trigger test jig
Creating a DSO trigger test jig
Creating a DSO trigger test jig
Creating a DSO trigger test jig
MIBAM waveform
Not so clean edge
Clean edge
Serial data at 9600bps
Serial data at 9600bps
Some signal
More details
Now with a voltage regulator
TSOP-ed my kitchen lights
ATtiny85 prototype
ATtiny85 IR receiver
He's dead Jim!
ATtiny85 IR receiver
Finally usable wire!
Lets see...
DO NOT EAT
Not enough space
Not enough space
Boxed up
Just two - ATtiny84
Humidity check
Humidity check
Keywords
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
158 visits
MIBAM waveform


This should be a representation of the number 1110 = 14. The small spikes are caused by interrupt code running. The low periods should have lengths of 2N, 4N, 8N. I'll have to try this again with an external trigger. There is too much jitter to get a stable image.
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2025
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.