PringCam 1.0

i made a pinhole camera out of this old Pringles can. I actually got it to produce an image.

This was the image from my PringCam 1.0 - I would deem it not a failure because it did turn out an image. The subject was tiny diecast tractors made by Ertl, less than an inch long. The problem was, when I started the nearly four-hour long exposure, the wind was not blowing at all. But, by the time the exposure ended, it had picked up to a brisk breeze and the tiny weeds in the background, (which look like trees) were blurred from motion. At least I know my PringCam works. Now, to work out a few minor bugs and try it out again under the new name of PringCam 1.1. Camera: PringCam 1.0 pinhole camera Film: Kentmere 100 ASA 35mm black and white film Pinhole size: .15mm Aperture: F/1747 Exposure length: 3 hours, 48 minutes Date: June 27th, 2012 Location: Norris City, Illinois, U.S.A. Developing chemicals at 68 degrees: Ilford ID-11 developer: 9 minutes Ilford Ilfostop stopbath: 1 minute Ilford Hypam fixer: 6 minutes Water rinse: 1 minutes PringCam 03c

The start of the little lane across the street that goes around the houses that line the street where I live. It’s called Cardinal Drive. The reason the picture is crooked is because I used some cut-down 120 film and it's hard to tell in the dark when you're loading it if you got it straight or not. Taken with my eighty-seventh camera. Camera: PringCam 1.0 pinhole camera Film: Fuji Film Neopan Acros 100 120 size (expired) Pinhole size: .15mm Aperture: F/1747 Exposure length: 1 minute Date: May 19th, 2023, 1.52 p.m. Location: Norris City, Illinois, U.S.A. Developing chemicals @68 degrees: Adox Adonal: 1:50 – 20 minutes (2 tsp. of Adonal/500 ml. water) Water Rinse: 1 minute Ilford Ilfostop Stopbath: 1 minute Water Rinse: 1 minute Kodak Kodafix Fixer: 9 minutes Water Rinse: 1 minute PringCam Fuji Acros 100 2023 01gf